.. csv-table::
    :header: "Command Syntax", "Extra information"
    :widths: 20, 30

    "

    | ``Eastron,Pause``
    | ``Eastron,Resume``

    ","
    | ``Pause`` and ``Resume`` refer to the continuous reading of set registers of all connected Eastron modules. 
    | When changing a setting on a specific module, this background register reading must be temporarily halted by calling ``Eastron,Pause`` first.
    | All commands are case insensitive.

    "
    "

    | ``Eastron,SetBaud,<new_baudrate>[,<node_id>]``
    | ``Eastron,SetID,<new_id>[,<node_id>]``

    ","
    | The optional ``<node_id>`` parameter indicates the current Modbus address. When not given, the default of address ``1`` is assumed.
    | Valid node IDs are ``1 ... 247``.
    | Call ``Eastron,Pause`` before changing settings on the module.
    | On some modules, like the SDM120, the user must press the button for 3 seconds to enter ``-set-`` mode.
    | After enabling the ``-set-`` mode, these commands can be given and then the user must press the button for 3 seconds to store the changed settings.
    |
    | Changing ID is active immediately, thus the new ID must be used for commands given after changing the ID.
    | Change of baud rate is only active after the module is power cycled.
    |
    | Allowed baud rates:
    | SDM120 / SDM230:
    | ``0`` = 2400 baud (default)
    | ``1`` = 4800 baud
    | ``2`` = 9600 baud
    | ``5`` = 1200 baud
    | 
    | SDM320 / SDM530Y:
    | ``0`` = 2400 baud
    | ``1`` = 4800 baud
    | ``2`` = 9600 baud (default)
    | ``5`` = 1200 baud
    | 
    | SDM630 / SDM72 / SDM72V2:
    | ``0`` = 2400 baud
    | ``1`` = 4800 baud
    | ``2`` = 9600 baud (default)
    | ``3`` = 19200 baud
    | ``4`` = 38400 baud    
    |
    | The baud rate parameter can be given either as a value ``0`` ... ``5``, or the exact (supported) baud rate.
    |
    | All commands are case insensitive.

    "