.. csv-table::
    :header: "Command Syntax", "Extra information"
    :widths: 20, 30

    "
    ``digipot,reset``
    ","
    Sending this command to the task the digipot will be reset to the default wiper settings (128). When a ``RST`` pin is configured, that will be shortly pulled to GND to reset the hardware, else the initial settings will be set to the chip.

    On reset, the Initial Shutdown settings will *not* be applied!
    "
    "
    ``digipot,shutdown[,<wiper>]``

    ``<wiper>``: Optional wiper to shutdown.
    
    ``0`` = W0

    ``1`` = W1

    ``2`` = Both wipers (default when ommitted)
    ","
    This command will set the indicated wiper to Shutdown mode. When no wiper is given, then both wipers will be set to shutdown mode, optionally using the hardware ``SHDN`` pin if that's configured.

    Shutdown mode will be released when a value is set to a wiper.
    "
    "
    ``digipot,<wiper>,<value>``

    ``<wiper>``: Wiper to set the value for.
    
    ``0`` = W0

    ``1`` = W1

    ``2`` = Both wipers

    ``<value>``: Range 0..255 to set the wiper to.
    ","
    This command will set the provided value to the indicated wiper. When using wiper 2 (both), then a single command will change both values at the same moment.

    When setting a value to a wiper, it will also release the shutdown mode, when enabled.
    "